![](https://buildingreportauckland.co.nz/wp-content/uploads/2023/09/insp3-e1694411397161.jpg)
![](https://buildingreportauckland.co.nz/wp-content/uploads/2023/09/ins3.jpg)
Building Report
Building inspection involves thorough inspection of the property and reporting.
Any house will have defects, big or small in accordance with its age, maintenance, type of construction, materials used, workmanship and design. But as a buyer you should know them before so that you can plan your finances.
A right home inspection by a right professional with a right attitude will give you a clear picture of what the condition of the house is all about. That is what we promise at Right Home NZ Limited.
Site :
Orientation, exposure, vegetation, driveway, paths, surface water control, fence, retaining wall, steps etc.,
Subfloor:
Ground condition, alteration to structure, ventilation, insulation, plumbing, electrical, pest, moisture intrusion.
Exterior:
Cladding condition, eaves, fascia, soffit, gutter, downpipes, doors, windows, penetrations, flashings, vents, decks etc.
Roof Exterior:
Roof type, material, condition, drainage, flashings, penetrations, vents, chimney, drainage, skylights etc
Roof Space (Attic):
Alterations, structure condition, moisture intrusion, insulation, pest, fire wall, plumbing, electrical, clearance, ventilation etc
Interior:
Surfaces material, condition, windows, doors, stairs, kitchen counters, plumbing leaks, moisture intrusion around risky areas, shower, vanity, laundry, garage etc
Plumbing:
Visible pipe material, leaks, water heater, drainage blocks as observed from sink and shower.
Electrical:
Switchboard type, cable type, recommendations
Ancillary Spaces
![](https://buildingreportauckland.co.nz/wp-content/uploads/2023/09/Phone3d_10259-1024x577.jpg)
MOISTURE TESTING
During the course of Residential Property Inspection, moisture testing procedures will be undertaken around high risk areas and places of common fault. Any moisture concentrations detected during this inspection will be included within the report. We use TroTec T660 the latest, state of the art, non-invasive moisture meter to perform our mositure testing.
INFRARED THERMOGRAPHY
We perform Infrared Thermography during our inspection where required, which in conjunction with moisture meter helps to better identify any moisture intrusion and thermal anomalies. We use state of the art FLIR IR camera. (Conditions favouring)
![](https://buildingreportauckland.co.nz/wp-content/uploads/2023/09/Phone3d_8383-1024x577.jpg)
![](https://buildingreportauckland.co.nz/wp-content/uploads/2023/09/robot2-1024x768.jpg)
HIGH ROOF / SUBFLOOR INSPECTION
When needed / ordered, we use our drone camera to inspect the high roofs and for tight subfloor spaces, we use crawling robot camera. (conditions permitting)